Estimative Index Dosing Guide

Overview

The Estimative Index (EI) coined by Tom Barr is a straight forward method for providing nutrients for a planted tank. The idea behind EI is simply introducing an excess amount of nutrients within an aquarium, throughout the week. This excess of nutrients floods the water column and feeds the plants. This is an estimative method; measuring specific nutrient uptake rates is not necessary and no test kits are involved. EI provides a surplus of nutrients that helps to prevents plant deficiencies, and allows plant growth to out compete algae growth.

The process of which this is done is simple. Each day fertilizers are dosed, and the nutrients are absorbed by the plants. With this method being estimative, we can dose fertilizers according to general guidelines suited for our particular setup (see below). At the end of the week, one performs a 50% water change to ‘reset’ the nutrient load in the entire system. And then the entire dosing schedule is repeated.

The primary fertilizers are the macro nutrients - Nitrogen (N), Phosphorous (P), Potassium (K), and the micro nutrients – trace elements (Plantex CSM+B, Flourish). Iron (Fe) can also be supplemented if necessary.

The Estimative Index method works best for a high light and well planted aquarium. However it is not limited to lower light setups, smaller quantities of fertilizers should be dosed in those instances.

General Dosing Guideline for High Light and Well Planted Aquariums


10- 20 Gallon Aquariums
+/- 1/8 tsp KN03 (N) 3x a week
+/- 1/32 tsp KH2P04 (P) 3x a week
+/- 1/32 tsp (2ml) Trace Elements 3x a week
50% weekly water change


20-40 Gallon Aquariums
+/- ¼ tsp KN03 3x a week
+/- 1/16 tsp KH2P04 3x a week
+/- 1/16 tsp (5ml) Trace Elements 3x a week
50% weekly water change


40-60 Gallon Aquariums
+/- 1/2 tsp KN03 3x a week
+/- 1/8 tsp KH2P04 3x a week
+/- 1/8 (10ml) Trace Elements 3x a week
50% weekly water change


60 – 80 Gallon Aquariums
+/- 3/4 tsp KN03 3x a week
+/- ¼ tsp KH2P04 3x a week
+/- ¼ tsp (20ml) Trace Elements 3x a week
50% weekly water change


100 - 125 Gallon Aquarium
+/- 1 1/2 tsp KN03 3x a week
+/- ½ tsp KH2P04 3x a week
+/- ½ tsp (30ml) Trace Elements 3x a week
50% weekly water change

Example Dosing Regime for 29 Gallon:


Note: K2SO4 is not required for dosing unless you need the extra Potassium (K). This K is found in KN03 and KH2P04. Dosing these two according to above will yield sufficient K levels. Therefore, one will be fine dosing only KN03 and KH2P04, and Plantex. If one needs to increase their K levels with K2S04, add the same measured amount as KH2P04. For example, if one is dosing 1/2 tsp of KH2P04, then dose 1/2 tsp of K2S04. In true regards to EI, added excess K is not detrimental in any event.


EI target ranges
CO2 range 25-30 ppm
NO3 range 5-30 ppm
K+ range 10-30 ppm
PO4 range 1.0-2.0 ppm
Fe 0.2-0.5ppm or higher
GH range 3-5 degrees ~ 50ppm or higher
KH range 3-5


And...Finally you would need to Add Macro Fertilisers as below

MACRO

N, P, K

Nitrogen, Phosphorous and Potassium - the macro nutrients.

* 500 ml of distilled water
* 61 g (10.69 teaspoons, 3.63 tablespoons) Potassium nitrate (KNO3)
* 5.2 g (1 teaspoons) Potassium monophosphate (KP04)
* 10.8 g (2 teaspoons) Magnesium sulphate (MgSO4)
* 1.8 g (0.3 or 1/3 teaspoon) Potassium sulphate (KSO4)

3 times a week add 10 ml for a 20 gallon tank. Or 1-2 ml daily. Or 15 ml twice a week. This will add 30 ppm nitrate a week to a tank with corresponding correct proportions for the other macro nutrients.


& FE + Trace Elements as below

FE + Trace

Iron and trace elements.

* Use 71 grams (2.5 T) of Plantex CSM+B
* one liter of distilled water.

Use 1 cc per 2 gal to raise Fe 5.0 ppm. i:e 20 gal tank gets 10cc (two capfuls)

Dose daily, biweekly or weekly depending on bio load